|
Post by anoldmanreturns on Apr 16, 2012 19:33:53 GMT
Ok stripped engine for a check as bits of metal on sump magnet......all four small ends are knackered.....I was going to change the crank from the lightweight one fitted now. So looking for a standard crank and rods or may have to keep lightweight crank and get the rods bushed if someone knows where this can be done.....hummmmmmmmmmmmm would prefer a standard crank really
|
|
gaz69
New Member
Posts: 46
|
Post by gaz69 on Apr 16, 2012 19:37:16 GMT
|
|
|
Post by anoldmanreturns on Apr 16, 2012 20:12:21 GMT
Thanks Gaz will keep that in mind if a crank doesnt turn up...
been told the 2MG rods and pistons fit if any one has a set of rods and pistons
|
|
|
Post by anoldmanreturns on Apr 17, 2012 8:36:47 GMT
found an engine but it North Yorkshire is there a forum member somewhere near that can collect and meet me part way ? ;D ;D ;D ;D
|
|
|
Post by anoldmanreturns on Apr 17, 2012 11:09:57 GMT
ok all sorted the engine (cheeeeeeeeeep as chips) will be with me tomorrow teatime so I will continue to strip the race engine tonight, phew
|
|
|
Post by anoldmanreturns on Apr 18, 2012 20:13:45 GMT
engine arrived engine strip will start tomorrow........fingers crossed the crank is ok
|
|
|
Post by anoldmanreturns on Apr 19, 2012 21:05:31 GMT
need help on mains...my crank has some pink marked shells in it but they are not listed in the manual helpppppp
|
|